Deep Draw Cartridge Heater

C-DD
Deep Draw Cartridge Heater
  • Seamless Sheath - No Welded End Disk
  • 304 or 316 Stainless Steel Sheath
  • Electropolished (Option)
  • Diameters Available: 1/8", 3/8", 1/2", 5/8", 3/4" (.3175, .635, .9525, 1.27, 1.5875, 1.905 cm)
  • Lengths Up to 10" (25.4 cm)
  • High Watt Densities Available

Chromalox type C-DD industrial heaters use the same robust construction as our standard high watt density cartridge heater. This model is typically supplied with a bushing or flange for immersion applications, but can also be supplied with any of the standard "CIR" configuration and seal options. Sheath material is available in either 304 or 316 stainless steel. The units can be passivated or electropolished for additional corrosion resistance.

Deep drawing is a sheet metal process where a sheet metal blank is radially formed into a forming die with a punch. Traditional cartridge heaters use "as welded" or "drawn over mandril" tube construction, using strip that is formed into a tube and welded. Deep drawing eliminates any weld seams that are typical on traditional cartridge heaters. Deep drawing also eliminates the need for a welded end disk which if improperly manufactured can cause the ingress of moisture into the element. This product is ideal for use in critical applications and anywhere risk mitigation is a concern.

Medical:

  • Dialysis
  • Nebulizers
  • Hydrotherapy
  • Pathology Analysis
Analytical:
  • Chromatographs
  • Water Baths
  • Cleaners/Washers
Transportation:
  • Potable Water Heaters
  • Galley Equipment

C-DD uses the same robust construction as our standard high watt density cartridge heater. This model is typically supplied with a bushing or flange for immersion applications, but can also be supplied with any of the standard "CIR" configuration and seal options. Sheath material is available in either 304 or 316 stainless steel. The units can be passivated or electropolished for additional corrosion resistance.

C-DD-Table

Can't find what you're looking for?