Custom Designed Solutions - Component Heating Solutions

Custom Designed Solutions

Sort By:
Custom Solutions CES 4
316 Stainless Steel, Rod Baffle Support, Low Pressure Drop Design
Custom Solutions CES tn w babcock enc
Skid System Pollution Reduction NeNox Anhydrous Ammonia Vaporization Heater; 275 kW at 480v, 3ph ASME certified for 250 psig at 100 deg. F; 12"-300# steel construction; moisture resistant terminal housing completely potted with special urethane encapsulant compound to prevent moisture/condensation build-up on termination when operating below ambient temperatures; horizontal skid mounted and pre-wired to SCR control panel
Custom Solutions CES tn zm 2
Heat Transfer System; designed for use with syltherm heat transfer fluid 800 kW 480 V large capacity system; Div 2 Hazardous Area; special 500 GPM pumps equipped for 750 deg. F operation; special SCR/Stepper combination power control package to allow staging of base load and fine tune with SCR, reducing maintenance and cost vs. 100% SCR
Custom Solutions CES tn zm 1
Heat Transfer System; designed for use with syltherm heat transfer fluid 800 kW 480 V large capacity system; Div 2 hazardous area; special 500 GPM pumps equipped for 750 deg. F operation; special SCR/Stepper combination power control package to allow staging of base load and fine tune with SCR, reducing maintenance and cost vs. 100% SCR
Custom Solutions CES tn zu print 10
Hot Oil System; three zones vertically stacked with common expansion tank mounted on top of the unit; provided with electronic controls for each zone in a common cabinet.