XPMC Enclosure Heaters are specifically
designed to provide convective and radiant
heat for freeze protection and condensation
evaporation in localized, hazardous location
areas where combustible chemicals, solvents,
gases or liquids may be present. The XPMC
construction features an anodized aluminum
finned extrusion body, with heat sinks. This is
heated by a Chromalox cartridge heater that is
engineered to yield a precise surface temperature
and exceptionally long life. The units
may be ordered with body only, with body + 1
heat sink or with 2 heat sinks. Each additional
heat sink increases the maximum wattage of
the unit. Depending on the size of the area to
be heated multiples of XPMC heaters can be
used in tandem to achieve higher aggregate
wattages and maintain required temperature
T ratings.
The number of Heat Sinks may be adjusted to
suit the wattage and T-rating required. Units
may be ordered in 6" or 12" lengths from 120V
to 240V.
Temperature ratings of T2, T3 and T3C are
available.
- Allows for heat to be provided in areas otherwise inaccessible for other models.
- Higher wattages than the competition
- Available in 3 different T-ratings
- cCSAus certified for hazardous locations
- Excellent for freeze and condensation protection.
- Instrumentation Control Panels
- Petrochemical plants
- Chemical Plants
- On-shore and Off-shore Oil Rigs
- Motor Control Centers
- Pump Station Houses
- Safety Storage Cabinets for volatiles and chemicals
- Utility Gas Plants – Storage of LNG and Natural Gas